We photograph the damage, log moisture readings and send the paperwork your adjuster asks for, so you have less to chase.
The quote is free and you see the price before work begins. No surprise charges at the end.
Our crews are certified, insured and equipped for hardwood floor water damage. They find the hidden moisture and dry it properly.
You do not have to work out how bad it is on your own. Call, tell us what you see, and a Miami technician will explain the next step and what it should cost.
Wood floors react to water quickly. Moisture enters each board through its underside and edges, the boards swell and press together, and cupping begins as the edges lift above the middle. Cupping alone is no reason to give up on the floor. When drying starts within the first few days, solid hardwood frequently lies flat again. What matters is removing moisture from the wood and from its subfloor steadily and under control.
Drying mats are how our team handles wet wood floors. A vacuum unit attached to the sealed mats lifts water out by way of the seams and the wood itself, and dehumidifiers hold the room air at a dry level. Compared with carpet or drywall it is slower, commonly a week or more. Sanding has to wait until the wood is fully dry. Sand a cupped floor too soon and it will crown later.
Sanding cupped boards flat while they are still wet removes the raised edges. After the moisture leaves, each board is left with a raised center, which is crowning.
No air moves and no light reaches the gap between the hardwood and the subfloor. Mold in that layer cannot be seen from the room, and a musty odor is usually the first sign.
High heat or too much airflow pulls moisture from the surface faster than the core can follow. The result can be cracks, splits and permanent gaps between boards.
Nails and staples that stay wet begin to rust and lose holding power. The rust also bleeds into the wood as dark stains that sanding may not remove.
Readings are taken in the boards and the subfloor, and on dry flooring close by as a reference. The comparison shows how far down moisture reached and how likely the floor is to recover.
Standing water is extracted right away and rugs and furniture are moved off the wet area. The faster water stops feeding the seams, the less the boards swell.
We tape drying mats to the floor and attach them to a vacuum system, which draws moisture upward through the wood. Dehumidifiers control the room so the wood dries evenly without cracking.
Readings are logged every one to two days and the equipment stays until the wet zone equals the dry comparison areas. Then we tell you whether the floor needs refinishing, a few boards replaced, or nothing.
We save what can be dried properly and remove only what cannot. Moisture readings make that call, not guesswork.
Ask a Tech: (510) 447-5586| Material | Can usually be saved when | Has to be replaced when |
|---|---|---|
| Solid hardwood | Boards that cupped but remain nailed tight, if dried within days | Boards that buckled, cracked or turned black, plus anything touched by sewage |
| OSB or particle board | OSB that has not swollen at the panel edges | Swollen OSB and nearly any wet particle board |
| Floor finish | Light clouding that clears or buffs out once dry | Stained or flaking topcoat, fixed only by a sand and refinish |
| Paper or felt underlayment | Paper underlayment left in place when the floor dries flat | Underlayment exposed when boards come up, or with mold on it |
| Baseboards and shoe molding | Real wood pieces with no swelling or splitting | Composite trim with puffed, flaking lower edges |
Most of the water ends up beneath the boards, having run down through the joints. Underneath, the wood remains wet even after the face has been dried.
The edges come up as each board expands. A cloudy look can appear in the finish. Growth is able to begin below, on raw wood and on the subfloor panels.
Pressure grows through the whole floor as the wood expands. With fasteners losing their hold and boards compressing at the edges, some areas can lift away from the subfloor.
Buckling, black staining and mold under the boards become likely. Drying is usually no longer enough, and the bulk of the wet flooring has to be replaced.
Not seeing your question? Call and ask. It costs nothing to talk it through.
Call (510) 447-5586Take action now and prevent costly damage. Miami Restoration Co is ready to help.
Call (510) 447-5586 Now